Neighbor Allowas-In - Dell S6100 Configuration Manual

neighbor allowas-in

Set the number of times an AS number can occur in the AS path.
Syntax neighbor {ip-address | peer-group-name} allowas-in number
To return to the default value, use the no neighbor {ip-address | peer-group-name} allowas-in
command.
Parameters
ip-address
peer-group-name
number
Defaults Not configured.
Command Modes ROUTER BGP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
Usage Information
You cannot set this configuration for a peer that is associated with a peer group. Similarly, you cannot associate a
peer to a peer group if that peer is already configured with these settings.
Related Commands
•
(OPTIONAL) Enter the IP address of the neighbor in dotted decimal format.
Enter the name of the peer group to set the advertisement interval for all routers in the
peer group.
Enter a number of times to allow this neighbor ID to use the AS path. The range is from 1
to 10.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
bgp four-octet-as-support — enable 4-byte support for the BGP process.
Border Gateway Protocol 381