Dell S6100 Configuration Manual page 843

To turn off debugging, use the no debug isis [vrf vrf—name] updates [interface] command.
Parameters
vrf vrf-name
interface
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.2(0.2)
9.0.2.0
8.3.19.0
8.3.12.0
6.3.1.0
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable the
debugging information on IS-IS corresponding to that VRF. This information contains local
updates tied to the VRF that you specify. This command displays the local LSP debugging
details of the current unit.
(OPTIONAL) Identifies the interface type as one of the following:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the Z9000.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced.
Intermediate System to Intermediate System (IS-IS) 843