Ip Ftp Source-Interface - Dell S6100 Configuration Manual

Version
8.3.11.1
8.1.1.0
7.6.1.0
7.5.1.0
E-Series
Usage Information The password is listed in the configuration file; you can view the password by entering the show running-
config ftp command.
Use the ip ftp password command when you use the ftp: parameter in the copy command.
Related Commands

ip ftp source-interface

Specify an interface's IP address as the source IP address for FTP connections.
Syntax ip ftp source-interface interface
To delete an interface, use the no ip ftp source-interface interface command.
Parameters
interface
Defaults The IP address on the system that is closest to the Telnet address is used in the outgoing packets.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
104 Control and Monitoring
Description
Introduced on the Z9000.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Original command.
Enter the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port-channel interface, enter the keywords port-channel then the port-
channel ID.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
• For a tunnel interface, enter the keyword tunnel.