Show Bootvar - Dell S6100 Configuration Manual

Example
Dell#show boot system stack-unit 1
Current system image information in the system:
===============================================
Type
----------------------------------------------------
stack-unit 1
Dell#

show bootvar

Display the variable settings for the boot parameters.
Syntax show bootvar
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.4
8.3.11.1
8.3.7.0
7.5.1.0
E-Series
Example
Dell# show bootvar
PRIMARY IMAGE FILE =
SECONDARY IMAGE FILE =
DEFAULT IMAGE FILE =
LOCAL CONFIG FILE =
PRIMARY HOST CONFIG FILE =
SECONDARY HOST CONFIG FILE =
PRIMARY NETWORK CONFIG FILE =
SECONDARY NETWORK CONFIG FILE =
CURRENT IMAGE FILE =
CURRENT CONFIG FILE 1 =
CURRENT CONFIG FILE 2 =
CONFIG LOAD PREFERENCE =
BOOT INTERFACE GATEWAY IP ADDRESS =
72 File Management
Boot Type A
FLASH BOOT 9.10(0.0)
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Output expanded to display current reload mode (normal or Jumpstart).
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the C-Series.
Original command.
system://B
tftp://10.16.127.35/FTOS-S6100-ON-9.8.1.0.bin
system://A
variable does not exist
variable does not exist
variable does not exist
variable does not exist
system://B
flash://startup-config
variable does not exist
local first
B
9.10(0.0) [boot]
variable does not exist
10.16.132.254