Ipv6 Dhcp Snooping Trust - Dell S6100 Configuration Manual

Version
8.3.11.1
8.3.7.0
8.3.1.0
7.8.1.0

ipv6 dhcp snooping trust

Configure an interface as trusted for DHCP snooping.
Syntax [no] ipv6 dhcp snooping trust
To disable dhcp snooping trusted capability on this interface, use the no ipv6 dhcp snooping trust
command.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
ip dhcp source-address-validation
Enable the IP Source Guard.
Syntax [no] ip dhcp source-address-validation [ipmac] [vlan vlan-id]
Parameters
ipmac
vlan vlan-id
Defaults Disabled
Command Modes
INTERFACE
INTERFACE PORTCHANNEL
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the C-Series and S-Series.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S4810, S4820T, S6000, S6000-ON, and Z-Series.
Enable IP+MAC Source Address Validation.
(OPTIONAL) SAV validates the source IP address along with the source VLAN ID against
the DHCP snooping binding table.
Dynamic Host Configuration Protocol (DHCP) 569