Permit - Dell S6100 Configuration Manual

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.7.0
8.4.2.1
8.2.1.0
7.8.1.0
7.4.1.0

permit

To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP.
Syntax permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp}
To remove this filter, you have two choices:
•
•
Parameters
ip-protocol-number
icmp
ipv6
tcp
udp
Defaults Not configured.
Command Modes ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the E-Series.
Introduced on the C-Series.
Introduced on the E-Series. Added the monitor option.
Use the no seq sequence-number command syntax if you know the filter's sequence number
Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command
Enter an IPv6 protocol number. The range is from 0 to 255.
Enter the keyword icmp to filter internet Control Message Protocol version 6.
Enter the keyword ipv6 to filter any internet Protocol version 6.
Enter the keyword tcp to filter the Transmission Control protocol.
Enter the keyword udp to filter the User Datagram Protocol.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
IPv6 Access Control Lists (IPv6 ACLs) 827