Interface - Dell S6100 Configuration Manual

Hide thumbs Also See for S6100:

Table of Contents

interface

Configure a physical or virtual interface on the switch.

interface interface

Not configured.

Command Modes

CONFIGURATION

Command History

This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking

OS Command Line Reference Guide.

Enter one of the following keywords and the interface information:

For a null interface, enter the keyword null then the slot/port information. The Null

interface number is 0.

For the Management interface on the stack-unit, enter the keyword

ManagementEthernet then the slot/port information.

For a Loopback interface, enter the keyword loopback then a number from 0 to

For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then

the stack/slot/port/subport information.

For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the

stack/slot/port/subport information.

For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/

slot/port[/subport] information.

For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/

slot/port/subport information.

For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the

stack/slot/port information.

For a Tunnel interface, enter the keyword tunnel then the tunnel ID. The range is

from 1 to 16383.

For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.

For a port channel interface, enter the keywords port-channel then a number.

Introduced on the S6010-ON and S4048T-ON.

Table of Contents