Match Ip Next-Hop - Dell S6100 Configuration Manual

Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
pre-6.1.1.0
Related Commands
•
•
•
•
•
•

match ip next-hop

To match based on the next-hop IP addresses specified in an IP access list or IP prefix list, configure a filter.
Syntax match ip next-hop {prefix-list prefix-list-name}
To delete a match, use the no match ip next-hop {prefix-list prefix-list-name} command.
Parameters
prefix-list prefix-list-
name
266 Access Control Lists (ACL)
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
match interface — redistribute routes that match the next-hop interface.
match ip next-hop — redistribute routes that match the next-hop IP address.
match ip route-source — redistribute routes that match routes advertised by other routers.
match metric — redistribute routes that match a specific metric.
match route-type — redistribute routes that match a route type.
match tag — redistribute routes that match a specific tag.
Enter the keywords prefix-list and then enter the name of configured prefix list, up
10 140 characters.