Ip Multicast-Routing - Dell S6100 Configuration Manual

Version
9.10(0.1)
9.10(0.0)
9.10(0.0)
9.8(2.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.7.0
7.8.1.0
7.6.1.0
Usage Information This feature allows you to limit the number of multicast entries on the system. This number is the total of all the
multicast entries on all line cards in the system. On each line card, the multicast module only installs the maximum
number of entries, depending on the configured CAM profile.
To store multicast routes, use the IN-L3-McastFib CAM partition. It is a separate hardware limit that exists per
port-pipe. This hardware space limitation can supersede any software-configured limit. The opposite is also true,
the CAM partition might not be exhausted at the time the system-wide route limit set by the ip multicast-
limit command is reached.
Related Commands
•

ip multicast-routing

Enable IP multicast forwarding.
Syntax ip multicast-routing [vrf vrf-name]
To disable multicast forwarding, use the no ip multicast-routing [vrf vrf-name] command.
Defaults Disabled.
Parameters
vrf vrf-name
Command Modes CONFIGURATION
1020 Multicast
Description
Introduced on the S6010-ON and S4048T-ON.
Introduced on the S3148.
Introduced on the S6100–ON.
Introduced on the S3100 series.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Added support for VRF. Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the C-Series.
Introduced on the E-Series.
show ip igmp groups — display the IGMP groups.
(OPTIONAL) Enter the keyword vrf followed by the name of the VRF to enable IP
multicast forwarding on that VRF.