Dell S6100 Configuration Manual page 150

Defaults
•
•
•
•
•
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
9.0.0.0
8.3.19.0
8.3.12.0
8.3.11.1
8.2.1.0
8.1.1.0
7.9.1.0
7.6.1.0
7.5.1.0
7.4.1.0
E-Series
Usage Information When you enter the traceroute command without specifying an IP address (Extended Traceroute), you are
prompted for a target and source IP address, timeout (in seconds) (default is 5), a probe count (default is 3),
minimum TTL (default is 1), maximum TTL (default is 30), and port number (default is 33434). To keep the default
setting for those parameters, press the ENTER key.
For IPv6, you are prompted for a minimum hop count (default is 1) and a maximum hop count (default is 64).
Example (IPv4)
Dell# traceroute www.Dell Networking.com
Translating "www.Dell Networking.com"...domain server (10.11.0.1) [OK]
Type Ctrl-C to abort.
150 Control and Monitoring
Timeout = 5 seconds
Probe count = 3
30 hops max
40 byte packet size
UDP port = 33434
EXEC
EXEC Privilege
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the Z9000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the Z9000.
Introduced on the E-Series with IPv6.
Introduced on the E-Series (IPv4 only).
Introduced VRF.
Added support for the S-Series.
Introduced on the C-Series.
Added support for IPv6 address on the E-Series.
Original command.