Ipv4 Unicast-Host-Route - Dell S6100 Configuration Manual

Version
9.8(0.0P2)
9.7(0.0)
9.4(0.0)
Usage Information Use this command to add the IPv4 catch-all route (0.0.0.0/0) in the LPM route forwarding table if it was deleted
using the no ip unknown-unicast command previously. This will be the default configuration after reload.

ipv4 unicast-host-route

Enable programming of IPv4 /32 route prefixes in L3 host table.
Syntax [no] ipv4 unicast-host-route
Defaults Disabled by default. By default, all the IPv4 route prefixes are installed only in the LPM table.
Command Modes CONFIGURATION
Command History
Version
9.10(0.0)
9.8(1.0)
9.7(0.0)
9.3(0.1)
9.2(1.0)
Usage Information A warning message is displayed when you enter this command stating that this setting takes effect for existing
routes only when IPv4 route prefixes are cleared from the routing table (RTM). To disable this functionality, use no
ipv4 unicast-host-route command.
Example
Dell(conf)#ip unicast-host-route
Warning: Command will take effect for existing routes only when IPv4
route prefixes are cleared from RTM
Dell(conf)#no ip unicast-host-route
show ip tcp initial-time
Displays the interval that you configured for the device to wait before the TCP connection is attempted to be established.
Syntax show ip tcp initial-time
Command Modes
EXEC
EXEC Privilege
778 IPv4 Routing
Description
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the S–Series.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the Z9500.