Dell S6100 Configuration Manual page 742

• load-balance hg
• management route
• show arp
• show arp retries
• show hosts
• show ip cam stack-unit
• show ip fib stack-unit
• show ip flow
• show ip interface
• show ip management-route
• show ipv6 management-route
• show ip protocols
• show ip route
• show ip route list
• show ip route summary
• show ip traffic
• show tcp statistics
arp
To associate an IP address with a MAC address in the switch, use address resolution protocol (ARP).
Syntax arp [vrf vrf-name] ip-address mac-address interface
To remove an ARP address, use the no arp ip-address command.
Parameters
vrf vrf-name
ip-address
mac-address
interface
Defaults Not configured.
Command Modes CONFIGURATION
742 IPv4 Routing
Enter a VRF name to configure an ARP entry for that VRF. Use the VRF option after the
keyword arp to configure a static arp on that particular VRF.
Enter an IP address in dotted decimal format.
Enter a MAC address in nnnn.nnnn.nnnn format.
(OPTIONAL) Enter any of the following keywords and slot/port or number information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For the Management interface on the stack-unit, enter the keyword
ManagementEthernet then the slot/port information.
• For a port channel interface, enter the keywords port-channel then a number.