Ip Mirror-Access-Group - Dell S6100 Configuration Manual

Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
6.2.1.1
Usage Information You can assign one ingress ACL and one egress ACL to an interface.
To associate an access-list to a non-default VRF, use the vrf attribute of this command. You can use this
command at the interface context (physical/LAG) to apply the access-list to a range of VRFs.
The VRF MODE is not available for the default and management VRFs.
Related Commands
•
•

ip mirror-access-group

Assign an IP mirror access control to an interface.
Syntax
ip mirror-access-group access-list-name {in} [implicit-permit] [vlan vlan-id]
[optimized]
To remove an IP mirror-access-group configuration, use the no ip mirror-access-group access-list-
name {in | out} [implicit-permit] [vlan vlan-id] [optimized] command.
Parameters
access-list-name
in
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names were up
to 16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
NOTE: If you apply outbound(egress) IP acl on a switch port, the filter applies only for routed traffic
egressing out of that port.
ip access-list standard — configure a standard ACL.
ip access-list extended — configure an extended ACL.
Enter the name of a configured access list, up to 140 characters.
Enter the keyword in to apply the ACL to incoming traffic.
Access Control Lists (ACL) 187