Version
6.4.1.0
Usage Information
You cannot delete a Management port.
The Management port is enabled by default (no shutdown). To assign an IP address to the Management port,
use the ip address command.
Example
Dell(conf)# interface managementethernet 1/1
Dell(conf-if-ma-1/1)#
Related Commands
•
•
interface null
Configure a Null interface on the switch.
Syntax
interface null number
Parameters
number
Defaults
Not configured; number = 0
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
Description
Introduced
management route
— configure a static route that points to the Management interface or a forwarding router.
speed (Management interface)
Enter zero (0) as the Null interface number.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
— Set the speed for the Management interface.
Interfaces
679