Rename - Dell S6100 Configuration Manual

Version
8.3.11.1
8.3.7.0
7.7.1.0
7.6.1.0
Usage Information
RFC 3986 specifies that IPv6 host addresses in a uniform resource identifier (URI) must be enclosed in square
brackets, [X:X:X:X::X]. For maximum flexibility this command accepts IPv6 host addresses with or without the
square brackets.
After you upgrade the system image, by entering the command. specify the location where the Dell Networking OS
image used to boot the system is stored (boot system), save the configuration to the start-up config file
(write memory), and reload the system (reload).
Example
Dell# upgrade system tftp://10.11.8.12/dv-rainier-13 a:
00:39:32 : Discarded 1 pkts. Expected block num : 51.
Received block num: 50
!00:39:36 : Discarded 1 pkts. Expected block num : 65.
Received block num: 64
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!.......
...........!!!!!!!!!!!!!!!!!!!!!!!
93924044 bytes successfully copied
System image upgrade completed successfully.
!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!
Image upgraded to all
Dell#

rename

Rename a file in the local file system.
Syntax rename url url
Parameters
url
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
70 File Management
Description
Introduced on the Z9000. Added support for the SSD on the Z9000 only.
Introduced on the S4810.
Added support for TFTP and SCP.
Introduced on the S-Series.
Enter the following keywords and a filename:
• For a file on the internal Flash, enter flash:// followed by the filename.
• For a file on an NFS mounted file system, enter nfsmount:// followed by the
mount point and file path.
• For a file on an external USB drive, enter usbflash:// followed by the filename.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.