Match Ip Address - Dell S6100 Configuration Manual

Defaults Not configured.
Command Modes ROUTE-MAP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.5.1.0
8.1.1.0
7.6.1.0
7.5.1.0
6.1.1.0
Related Commands
•
•
•
•
•
•

match ip address

To match routes based on IP addresses specified in an access list, configure a filter.
Syntax match ip address prefix-list-name
To delete a match, use the no match ip address prefix-list-name command.
Parameters
prefix-list-name
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Added support for 4-port 40G line cards on the E-Series.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
match ip address — redistribute routes that match an IP address.
match ip next-hop — redistribute routes that match the next-hop IP address.
match ip route-source — redistribute routes that match routes advertised by other routers.
match metric — redistribute routes that match a specific metric.
match route-type — redistribute routes that match a route type.
match tag — redistribute routes that match a specific tag.
Enter the name of configured prefix list, up to 140 characters.
Access Control Lists (ACL) 265