Management Route - Dell S6100 Configuration Manual

management route

Configure a static route that points to the Management interface or a forwarding router.
Syntax management route {ip-address mask | ipv6-address 1.1.1.1prefix-length}
{forwarding-router-address | managementethernet | fortyGigE | vlan |
tengigabitethernet}
To remove a static route, use the no management route command.
Parameters
ip-address mask
ipv6-address prefix-
length
forwarding-router-
address
managementethern
et
fortyGigE
vlan
tengigabitethernet
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.0.2.0
9.0.0.0
Enter an IP address (dotted decimal format) and mask (/prefix format) of the destination
subnet.
Enter an IPv6 address (x:x:x:x::x format) and mask (/prefix format) of the destination
subnet. Enter the IPv6 address in the x:x:x:x::x format followed by the prefix length in
the /x format.
The range is from /0 to /128.
NOTE: The :: notation specifies successive hexadecimal fields of zeros.
Enter an IP address (dotted decimal format) or an IPv6 address (x:x:x:x::x format) of a
forwarding router.
Enter the keyword managementethernet for the Management interface on the
Primary RPM.
Enter the keyword fortyGigE to specify a forty Gigbit Ethernet interface.
Enter the keyword vlan to specify a vlan interface.
Enter the keyword tengigabitethernet to specify a ten Gigabit Ethernete interface.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Added support for forty gigabit, vlan, and tengigabit ethernet interfaces. Introduced on
the S6000-ON.
Introduced on the S6000.
Introduced on the Z9000 and added support for IPv6.
IPv4 Routing 783