Dcbx Commands - Dell S6100 Configuration Manual

State Machine Type is Feature
Conf TLV Tx Status is enabled
Example (Detail)
Dell(conf)#do show int te 1/1/1/1 ets detail
Interface TenGigabitEthernet 1/1/1/1
Max Supported PG is 4
Number of Traffic Classes is 8
Admin mode is on
Admin Parameters :
------------------
Admin is enabled
PG-grp
----------------------------------------------------------------------------------
0
1
2
3
4
5
6
7
15
Remote Parameters :
-------------------
Remote is disabled
Local Parameters :
------------------
Local is enabled
PG-grp
----------------------------------------------------------------------------------
0
1
2
3
4
5
6
7
15
Oper status is init
ETS DCBX Oper status is Down
Reason: Port Shutdown
State Machine Type is Feature
Conf TLV Tx Status is enabled
23 Input Conf TLV Pkts, 47 Output Conf TLV Pkts, 0 Error Conf TLV Pkts

DCBX Commands

The following DCBX commands are supported on the Dell Networking OS.
advertise dcbx-tlv
On a DCBX port with a manual role, configure the PFC and ETS TLVs advertised to DCBX peers.
Syntax advertise dcbx-tlv {ets-conf | ets-reco | pfc} [ets-conf | ets-reco | pfc]
[ets-conf | ets-reco | pfc]
To remove the advertised ETS TLVs, use the no advertise dcbx-tlv command.
Parameters
{ets-conf | ets-reco
| pfc}
Priority# BW-%
%
0,1,2,3,4,5,6,7 100
-
-
-
-
-
-
-
-
Priority# BW-%
%
0,1,2,3,4,5,6,7 100
-
-
-
-
-
-
-
-
Enter the PFC and ETS TLVs advertised, where:
BW-COMMITTED
Rate(Mbps) Burst(KB) Rate(Mbps) Burst(KB)
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
BW-COMMITTED
Rate(Mbps) Burst(KB) Rate(Mbps) Burst(KB)
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
BW-PEAK TSA
- ETS
- -
- -
- -
- -
- -
- -
- -
- -
BW-PEAK TSA
- ETS
- -
- -
- -
- -
- -
- -
- -
- -
Data Center Bridging (DCB) 489