Ip Telnet Server Enable - Dell S6100 Configuration Manual

Related Commands
•
ip ftp vrf
Configures an FTP client with a VRF that is used to connect to the FTP server.
Syntax ip ftp [vrf {vrf-name | management}]
To undo the FTP client configuration, use the ip ftp [vrf vrf-name] command.
Parameters
vrf-name
management
Defaults Disabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.0)
9.4(0.0)
Usage Information Use this command to make the FTP clients VRF-aware. The VRF name that you specify is used by the FTP client
to reach the FTP server. If no VRF name is specified, then the default VRF is used.

ip telnet server enable

Enable the Telnet server on the switch.
Syntax ip telnet server enable
To disable the Telnet server, use the no ip telnet server enable command.
Defaults Enabled
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
ip ftp password — sets the password for FTP connections.
Enter the vrf-name to specify the VRF that is used by the FTP client.
Enter the keyword management to specify that the VRF used by the FTP client is a
management VRF.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S-Series and Z9000.
Control and Monitoring 107