Shutdown - Dell S6100 Configuration Manual

•

shutdown

Disable an interface.
Syntax shutdown
To activate an interface, use the no shutdown command.
Defaults The interface is disabled.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
E-Series legacy
command
Usage Information
The shutdown command marks a physical interface as unavailable for traffic. To discover if an interface is
disabled, use the show ip interface brief command. Disabled interfaces are listed as down.
Disabling a VLAN or a port channel causes different behavior. When a VLAN is disabled, the Layer 3 functions
within that VLAN are disabled. Layer 2 traffic continues to flow. Entering the shutdown command on a port
channel disables all traffic on the port channel and the individual interfaces within the port channel. To enable a
port channel, enter no shutdown on the port channel interface and at least one interface within that port
channel.
The shutdown and description commands are the only commands that you can configure on an interface
that is a member of a port channel.
Related Commands
•
•
722 Interfaces
show ip interface — display Layer 3 information about the interfaces.
Description
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
interface port-channel — create a port channel interface.
interface vlan — create a VLAN.