cam-acl
Allocate content addressable memory (CAM) for IPv4 and IPv6 ACLs.
Syntax
cam-acl {default | l2acl number ipv4acl number ipv6acl number ipv4qos number
l2qos number l2pt number ipmacacl number [vman-qos | vman-dual-qos] number
{fcoeacl number} {openflow {4|8}}
Parameters
default
Command Modes
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(2.0)
9.8(1.0)
Use the default CAM profile settings and set the CAM as follows:
•
L2Acl : 2
•
Ipv4Acl : 2
•
Ipv6Acl : 0
•
Ipv4Qos : 2
•
L2Qos : 2
•
L2PT : 0
•
IpMacAcl : 1
•
VmanQos : 0
•
EtsAcl : 0
•
FcoeAcl : 0
•
iscsiOptAcl : 0
•
ipv4pbr : 0
•
vrfv4Acl : 0
•
Openflow : 0
•
fedgovacl : 0
•
nlbclusteracl: 0
Allocate space to each CAM region.
Enter the CAM profile name then the amount of CAM space to be allotted. The total
space allocated must equal to 9. The ipv6acl range must be a factor of 3.
Enter 4 or 8 for the number of OpenFlow FP blocks.
•
4: Creates 242 entries for use by the OpenFlow controller (256 total entries minus the
14 entries reserved for internal functionality)
•
8: Creates 498 entries for use by the OpenFlow controller (512 total entries minus the
14 entries reserved for internal functionality)
Description
Introduced on the S6100-ON.
Introduced on the S3100 series.
Introduced on the Z9100–ON.
Control and Monitoring
89