Set As-Path - Dell S6100 Configuration Manual

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.8.1.0
7.6.1.0
7.5.1.0
pre-6.1.1.0
Usage Information Use caution when you delete route maps because if you do not specify a sequence number, all route maps with the
same map-name are deleted when you use the no route-map map-name command.
Example
Dell(conf)# route-map dempsey
Dell(config-route-map)#
Related Commands
•

set as-path

To modify the AS path for border gateway protocol (BGP) routes, configure a filter.
Syntax set as-path prepend as-number [... as-number]
To remove an AS-Path setting, use the no set as-path {prepend as-number | tag} command.
Parameters
prepend as-number
Defaults Not configured.
Command Modes ROUTE-MAP
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Increased the name string to accept up to 140 characters. Prior to 7.8.1.0, names are up to
16 characters long.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
show config — display the current configuration.
Enter the keyword prepend and then enter up to eight AS numbers to be inserted into
the BGP path information. The range is from 1 to 65535.
Access Control Lists (ACL) 273