Cam-Acl-Egress - Dell S6100 Configuration Manual

!
interface TenGigabitEthernet 1/1/1/1
no ip address
ipv6 access-group AclList1 in implicit-permit Vlan 10-20
no shutdown
Dell(conf-if-te-1/1/1/1)#

cam-acl-egress

Allocate space for IPv6 egress ACLs.
Syntax cam-acl-egress {default | l2acl 1-4 ipv4acl 1-4 ipv6acl 0-4}
Parameters
default
l2acl 1-4 ipv4acl 1- 4
ipv6acl 0-4
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.4.2.0
8.2.1.0
7.8.1.0
Use the default CAM profile settings, and set the CAM as follows:
• L2 ACL(l2acl): 1
• L3 ACL (ipv4acl: 1
• IPv6 L3 ACL (ipv6acl): 2
Allocate space to support IPv6 ACLs. Enter all of the profiles and a range. Enter the CAM
profile name then the amount to be allotted. The total space allocated must equal 4. The
ipv6acl range must be a factor of 2.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
IPv6 Access Control Lists (IPv6 ACLs) 831