Ipv6 Icmp Source-Interface - Dell S6100 Configuration Manual

ipv6 icmp source-interface

Enable the ICMP error and unreachable messages to be sent with the source interface IP address, such as the loopback address, instead of
the hops of the preceding devices along the network path to be used for easy debugging and diagnosis of network disconnections and
reachability problems with IPv6 packets.
Syntax ipv6 icmp source-interface interface
Parameters
interface
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.3(0.0)
Enter one of the following keywords and slot/port or number information:
• For a Management Ethernet interface, enter the keyword managementethernet.
NOTE: When you configure the capability to enable the loopback IP
address to be sent for easy debugging and diagnosis (IP addresses of
the devices for which the ICMP source interface is configured), the
source IP address of the outgoing ICMP error message is modified,
although the packets are not sent out using the configured interface.
Because the management interface is configurable only without any
parameters such as the IP address, it is treated to the management
interface of the primary unit or the existing unit.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
• For a Loopback interface, enter the keyword loopback then a number from 0 to
16383.
• For a port channel interface, enter the keywords port-channel then a number.
• For a VLAN interface, enter the keyword vlan then a number from 1 to 4094.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the S4810, S4820T, S6000, and Z9000 platforms.
IPv4 Routing 769