Ip Icmp Source-Interface - Dell S6100 Configuration Manual

ip address
Defaults Not configured.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
pre-6.1.1.0

ip icmp source-interface

Enable the ICMP error and unreachable messages to be sent with the source interface IP address, such as the loopback address, instead of
the hops of the preceding devices along the network path to be used for easy debugging and diagnosis of network disconnections and
reachability problems with IPv4 packets.
Syntax ip icmp source-interface interface
Parameters
interface
Enter an IP address, in dotted decimal format, to be mapped to the name.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced for the E-Series.
Enter one of the following keywords and slot/port or number information:
• For a Management Ethernet interface, enter the keyword managementethernet.
NOTE: When you configure the capability to enable the loopback IP
address to be sent for easy debugging and diagnosis (IP addresses of
the devices for which the ICMP source interface is configured), the
source IP address of the outgoing ICMP error message is modified,
although the packets are not sent out using the configured interface.
Because the management interface is configured without any
parameters such as the IP address, it is treated to the management
interface of the primary unit or the existing unit.
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
IPv4 Routing 767