Dell S6100 Configuration Manual page 930

Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.12.0
8.5.1.0
8.3.7.0
7.6.1.0
7.5.1.0
pre-6.2.1.1
Usage Information The following describes the show mac-address-table command shown in the following example.
Column Heading Description
VlanId
Mac Address
Type
Interface
State
Example
Dell(conf)# do show mac-address-table
Codes: *N - VLT Peer Synced MAC
VlanId
2
2
930 Layer 2
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Updated the output.
Added support for 4-port 40G line cards on the E-Series.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
Displays the VLAN ID number.
Displays the MAC address in nn:nn:nn:nn:nn:nn format.
Lists whether the MAC address was manually configured (Static), learned dynamically
(Dynamic), or associated with a specific port (Sticky).
Displays the interface type and slot/port[/subport] information. The following
abbreviations describe the interface types:
• Po = port channel
• Te = ten-gigabit Ethernet
• Fo = forty-gigabit Ethernet
• Tf = twentyfive-gigabit Ethernet
• Fi = fifty-gigabit Ethernet
• Hu = hundred-gigabit Ethernet
Lists if the MAC address is in use (Active) or not in use (Inactive).
Mac Address
00:00:00:00:00:01
00:00:00:00:00:02
Type Interface
Dynamic (N) Po 128
Dynamic (N) Po 10
State
Active
Active