Debug Ip Bgp Keepalives - Dell S6100 Configuration Manual

Version
7.7.1.0
Usage Information
To remove all configured debug commands for BGP, enter the no debug ip bgp command.

debug ip bgp keepalives

Display information about BGP keepalive messages.
Syntax debug ip bgp [vrf vrf-name] [A.B.C.D | X:X:X:X::X | peer-group peer-group-name]
keepalives [in | out]
To disable debugging, use the no debug ip bgp [A.B.C.D | X:X:X:X::X | peer-group peer-
group-name] keepalives [in | out] command.
Parameters
A.B.C.D
X:X:X:X::X
peer-group peer-
group-name
in
out
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
370 Border Gateway Protocol
Description
Introduced on the C-Series.
(OPTIONAL) Enter the IPv4 address of the neighbor.
(OPTIONAL) Enter an IPv6 address.
(OPTIONAL) Enter the keyword peer-group then the name of the peer group.
(OPTIONAL) Enter the keyword in to view only inbound keepalive messages.
(OPTIONAL) Enter the keyword out to view only outbound keepalive messages.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.