Sent: 21 requests, 10 replies (0 proxy)
Routing Processor1 IP Traffic:
show tcp statistics
View information on TCP traffic through the switch.
Syntax
show tcp statistics {all | cp}
Parameters
all
cp
Command Modes
EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
6.4.1.0
Usage Information
The following describes the show tcp statistics cp command shown in the following example.
Field
Rcvd:
0 checksum error...
810
IPv4 Routing
Enter the keyword all to view all TCP information.
Enter the keyword cp to view only TCP information from the Control Processor.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced
Description
Displays the number and types of TCP packets received by the switch.
•
Total = total packets received
•
no port = number of packets received with no designated port
Displays the number of packets received with the following:
•
checksum errors
•
bad offset to data