Lacp Fast-Switchover - Dell S6100 Configuration Manual

lacp fast-switchover

Cause the physical ports to be aggregated faster by configuring this capability in a port-channel on both the nodes that are members of a
port-channel.
Syntax lacp fast-switchover
To disable the capability of faster aggregation of the member ports of a LAG or a port-channel bundle, use the no
version of this command.
Defaults Not configured
Command Modes INTERFACE (conf-if-po-number)
Command History
Version
9.10(0.0)
9.8(1.0)
9.3(0.0)
9.2(1.0)
Usage Information
You can configure the optimal switchover functionality for LACP even if you do not enable the fast boot mode on
the system. You must configure the long timeout mechanism for the LACP session to enable the fast boot
capability to operate properly. This command applies to dynamic port-channel interfaces only. When applied on a
static port-channel, this command has no effect
If you configure the optimized booting-time capability and perform a reload of the system, the LACP application
sends PDUs across all the active LACP links immediately.
Related Commands show lacp
encapsulation dot1q
Configures lite-subinterfaces.
Syntax encapsulation dot1q vlan-id
To remove a previously configured lite-subinterface, use the no encapsulation dot1q vlan-id command.
Parameters
dot1q vlan-id
Command Modes
INTERFACE
Command History
Version
9.10(0.0)
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S6000.
Introduced on the Z9500.
— displays the LACP configuration.
Enter the keyword dot1q followed by the VLAN ID to which the host belongs. The range
is from 1 to 4094. A lite subinterface is considered as a Layer 3 port property and is
synchronous with the existing rules of applying Layer 2 or Layer 3 properties to an
interface.
Description
Introduced on the S6100–ON.
Flex Hash and Optimized Boot-Up 593