Ip Domain-Lookup - Dell S6100 Configuration Manual

Version
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.1.1.0
7.6.1.0
7.5.1.0
Usage Information To configure a list of possible domain names, configure the ip domain-list command up to six times.
If you configure both the ip domain-name and ip domain-list commands, the software tries to resolve
the name using the ip domain-name command. If the name is not resolved, the software goes through the list
of names configured with the ip domain-list command to find a match.
To enable dynamic resolution of hosts, use the following steps:
•
•
To view current bindings, use the show hosts command. To view a DNS-related configuration, use the show
running-config resolve command.
Related Commands
•

ip domain-lookup

To address resolution (that is, DNS), enable dynamic host-name.
Syntax ip domain-lookup
To disable DNS lookup, use the no ip domain-lookup command.
Defaults Disabled.
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
762 IPv4 Routing
Description
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Introduced on the S-Series.
Introduced on the C-Series.
specify a domain name server with the ip name-server command
enable DNS with the ip domain-lookup command
ip domain-name — specify a DNS server.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.