Vrrp Mode - Dell S6100 Configuration Manual

SPANNING TREE Mode
To enable and configure the Spanning Tree protocol, use SPANNING TREE mode. For more information, see
To enter SPANNING TREE mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the protocol spanning-tree stp-id command. The prompt changes to include conf-stp.
You can return to CONFIGURATION mode by using the exit command.
SupportAssist Mode
To enable and configure the SupportAssist, use SupportAssist mode. For more information, see SupportAssist.
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the support-assist command. The prompt changes to include conf-supportassist.
You can return to CONFIGURATION mode by using the exit command.
TRACE-LIST Mode
To configure a Trace list, use TRACE-LIST mode.
To enter TRACE-LIST mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the ip trace-list command, and the name of the Trace list. The prompt changes to include conf-trace-acl.
You can exit this mode by using the exit command.
VLT DOMAIN Mode
To enable and configure the VLT domain protocol, use VLT DOMAIN mode. For more information, see
To enter VLT DOMAIN mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the vlt domain command, and then the VLT domain number. The prompt changes to include conf-vlt-domain.
You can return to CONFIGURATION mode by entering the exit command.

VRRP Mode

To enable and configure Virtual Router Redundancy Protocol (VRRP), use VRRP mode. For more information, see
Redundancy Protocol (VRRP).
To enter VRRP mode:
1 To enable VRRP globally, verify that you are logged in to CONFIGURATION mode.
56 CLI Basics
Spanning Tree Protocol
Virtual Link Trunking (VLT).
Virtual Router
(STP).