Hello - Dell S6100 Configuration Manual

Version
8.3.7.0
7.7.1.0
7.6.1.0
7.4.1.0
Related Commands
•
•
•

hello

Configure the rate at which the LLDP control packets are sent to its peer.
Syntax hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds
Defaults 30 seconds
Command Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.7.1.0
962 Link Layer Discovery Protocol (LLDP)
Description
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
protocol lldp (Configuration)
debug lldp interface — debug LLDP.
show lldp neighbors — display the LLDP neighbors.
Enter the rate, in seconds, at which the control packets are sent to its peer. The rate is
from 5 to 180 seconds. The default is 30 seconds.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
— enable LLDP globally.