Dell S6100 Configuration Manual page 435

The Lines
Beginning with:
(list of inbound and
outbound policies)
For address family:
BGP table version
accepted prefixes
Prefix advertised
Connections
established
Last reset
Local host:
Foreign host:
Example
Dell# show ip bgp neighbors 172.16.0.2
BGP neighbor is 172.16.0.2, remote AS 200, external link
Member of peer-group port0 for session parameters
BGP remote router ID 172.16.0.2
BGP state ESTABLISHED, in this state for 00:13:55
Last read 00:00:03, Last write 00:00:55
Hold time is 180, keepalive interval is 60 seconds
Received 50 messages, 0 in queue
Sent 18 messages, 0 in queue
Route refresh request: received 0, sent messages 1
Minimum time between advertisement runs is 30 seconds
Minimum time before advertisements start is 0 seconds
Capabilities received from neighbor for IPv4 Unicast :
Capabilities advertised to neighbor for IPv4 Unicast :
For address family: IPv4 Unicast
BGP local RIB : Routes to be Added 0, Replaced 0, Withdrawn 0
InQ : Added 0, Replaced 0, Withdrawn 0
OutQ : Added 0, Withdrawn 0
Allow local AS number 0 times in AS-PATH attribute
Prefixes accepted 2, withdrawn 15 by peer, martian prefixes ignored 0
Description
Displays the policy commands configured and the names of the Route map, AS-PATH
ACL, or Prefix list configured for the policy.
Displays the IPv4 Unicast as the address family.
Displays which version of the primary BGP routing table the router and the neighbor are
using.
Displays the number of network prefixes the router accepts and the amount of memory
used to process those prefixes.
Displays the number of network prefixes advertised, the number rejected, and the number
withdrawn from the BGP routing table.
Displays the number of TCP connections established and dropped between the two peers
to exchange BGP information.
Displays the amount of time since the peering session was last reset. Also states if the
peer resets the peering session. If the peering session was never reset, the word never is
displayed.
Displays the peering address of the local router and the TCP port number.
Displays the peering address of the neighbor and the TCP port number.
1 opens, 0 notifications, 34 updates
15 keepalives, 0 route refresh requests
1 opens, 0 notifications, 0 updates
16 keepalives, 0 route refresh requests
MULTIPROTO_EXT(1)
ROUTE_REFRESH(2)
MULTIPROTO_EXT(1)
ROUTE_REFRESH(2)
ADD_PATH(69)
CISCO_ROUTE_REFRESH(128)
Border Gateway Protocol 435