Garp Timers - Dell S6100 Configuration Manual

Version
8.3.11.1
8.3.7.0
7.6.1.0
Related Commands
•
•

garp timers

Set the intervals (in milliseconds) for sending GARP messages.
Syntax garp timers {join | leave | leave-all}
To return to the previous setting, use the no garp timers {join | leave | leave-all} command.
Parameters
join
leave
leave-all
Defaults As above.
Command Modes CONFIGURATION-GVRP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
626 GARP VLAN Registration (GVRP)
Description
Introduced on the Z9000.
Introduced on the S4810.
Introduced on C-Series, E-Series, and S-Series
gvrp enable — enable GVRP on physical interfaces and LAGs.
protocol gvrp — access GVRP protocol.
Enter the keyword join then the number of milliseconds to configure the join time. The
range is from 100 to 147483647 milliseconds. The default is 200 milliseconds.
NOTE:
Enter the keyword leave then the number of milliseconds to configure the leave time.
The range is from 100 to 2147483647 milliseconds. The default is 600 milliseconds.
NOTE:
Enter the keywords leave-all then the number of milliseconds to configure the leave-
all time. The range is from 100 to 2147483647 milliseconds. The default is 1000
milliseconds.
NOTE:
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Designate the milliseconds in multiples of 100.
Designate the milliseconds in multiples of 100.
Designate the milliseconds in multiples of 100.