Mac-Address-Table Aging-Time - Dell S6100 Configuration Manual

Version
8.3.1.0
7.6.1.0
7.5.1.0
pre-6.2.1.1
Related Commands
•
•

mac-address-table aging-time

Specify an aging time for MAC addresses to remove from the MAC address table.
Syntax mac-address-table aging-time seconds
Parameters
seconds
Defaults 1800 seconds
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
920 Layer 2
Description
On the E-Series, available in INTERFACE VLAN context, reduced the minimum aging time
in the INTERFACE VLAN context from 10 seconds to 1 second.
Introduced on the S-Series.
Introduced on the C-Series.
Introduced on the E-Series.
mac learning-limit — set the MAC address learning limits for a selected interface.
show mac-address-table aging-time
Enter either zero (0) or a number as the number of seconds before MAC addresses are
relearned. To disable aging of the MAC address table, enter 0. The range is from 10 to
1000000. The default is 1800 seconds.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
On the E-Series, available in INTERFACE VLAN context, reduced the minimum aging time
in the INTERFACE VLAN context from 10 seconds to 1 second.
— display the MAC aging time.