Dell S6100 Configuration Manual page 727

To remove an interface from Layer 2 mode and place it in Layer 3 mode, enter the no switchport command. If
a switchport backup interface is configured, first remove the backup configuration. To remove a switchport backup
interface, enter the no switchport backup interface command.
Parameters
backup
interface interface
port-channel
mode
private-vlan
host
promiscuous
trunk
Defaults Disabled — interface is in Layer 3 mode.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
(OPTIONAL) Use this option to configure a redundant Layer 2 link without using Spanning
Tree. The keyword backup configures a backup port so that if the primary port fails, the
backup port changes to the up state. If the primary later comes up, it becomes the
backup.
(OPTIONAL) Enter any of the following keywords and the interface information:
• For a 10-Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then
the stack/slot/port/subport information.
• For a 25-Gigabit Ethernet interface, enter the keyword twentyFiveGigE then the
stack/slot/port/subport information.
• For a 40-Gigabit Ethernet interface, enter the keyword fortyGigE then the stack/
slot/port[/subport] information.
• For a 50-Gigabit Ethernet interface, enter the keyword fiftyGigE then the stack/
slot/port/subport information.
• For a 100-Gigabit Ethernet interface, enter the keyword hundredGigE then the
stack/slot/port information.
(OPTIONAL) Enter the keywords port-channel if the backup port is a static or
dynamic port channel.
(OPTIONAL) Enter the keyword mode to set the interface mode.
(OPTIONAL) Enter the keywords private-vlan to set the interface mode to private
VLAN mode.
(OPTIONAL) Enter the keyword host to set the private VLAN interface to host mode.
(OPTIONAL) Enter the keyword promiscuous to set the private VLAN interface to
promiscuous mode.
(OPTIONAL) Enter the keyword trunk to set the private VLAN interface to trunk mode.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Interfaces 727