Permit Udp - Dell S6100 Configuration Manual

permit udp

permit udp
Configure a filter to pass UDP packets meeting the filter criteria.
Syntax permit udp {source address mask | any | host ipv6-address} [operator port
[port]] {destination address | any | host ipv6-address} [operator port [port]]
[count [byte]] | [log] [monitor]
To remove this filter, you have two choices:
•
•
Parameters
source address
mask
any
host ipv6-address
operator
port port
destination address
count
byte
Defaults Not configured.
Command Modes ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
234 Access Control Lists (ACL)
– assigns a permit filter for UDP packets.
Use the no seq sequence-number command if you know the filter's sequence number.
Use the no permit udp {source address mask | any | host ipv6-address}
{destination address | any | host ipv6-address} command.
Enter the IPv6 address of the network or host from which the packets were sent in the
x:x:x:x::x format followed by the prefix length in the /x format. The range is /0 to /128.
The :: notation specifies successive hexadecimal fields of zero.
Enter a network mask in /prefix format (/x).
Enter the keyword any to specify that all routes are subject to the filter.
Enter the keyword host followed by the IPv6 address of the host in the x:x:x:x::x format.
The :: notation specifies successive hexadecimal fields of zero.
(OPTIONAL) Enter one of the following logical operand:
• eq = equal to
• neq = not equal to
• gt = greater than
• lt = less than
• range = inclusive range of ports (you must specify two port for the port parameter.)
(OPTIONAL) Enter the application layer port number. Enter two port numbers if using the
range logical operand. The range is 0 to 65535.
Enter the IPv6 address of the network or host to which the packets are sent in the
x:x:x:x::x format followed by the prefix length in the /x format. The range is /0 to /128.
The :: notation specifies successive hexadecimal fields of zero.
(OPTIONAL) Enter the keyword count to count packets processed by the filter.
(OPTIONAL) Enter the keyword byte to count bytes processed by the filter.