Fcoe Priority-Bits - Dell S6100 Configuration Manual

Version
9.0.2.0
8.3.19.0
8.3.12.0
8.3.16.0

fcoe priority-bits

Configure the FCoE priority advertised for the FCoE protocol in application priority TLVs.
Syntax fcoe priority-bits priority-bitmap
To remove the configured FCoE priority, use the no fcoe priority-bits command.
Parameters
priority-bitmap
Defaults 0x8
Command Modes PROTOCOL LLDP
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.12.0
8.3.16.0
Usage Information This command is available at the global level only.
iscsi priority-bits
Configure the iSCSI priority advertised for the iSCSI protocol in application priority TLVs.
Syntax iscsi priority-bits priority-bitmap
To remove the configured iSCSI priority, use the no iscsi priority-bits command.
Parameters
priority-bitmap
Defaults 0x10
Description
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the priority-bitmap range. The range is from 1 to FF.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S6000-ON and Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.
Enter the priority-bitmap range. The range is from 1 to FF.
Data Center Bridging (DCB) 493