Fefd Disable - Dell S6100 Configuration Manual

Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.12.0
Usage Information When you enter no fefd for an interface and fefd-global, FEFD is enabled on the interface because the no
fefd command is not retained in the configuration file. To keep the interface FEFD disabled when the global
configuration changes, use the fefd reset command.
Related Commands
•
•
•

fefd disable

Disable FEFD on an interface only. This command overrides the fefd reset command for the interface.
Syntax fefd disable
To re-enable FEFD on an interface, use the no fefd disable command.
Defaults Not configured.
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2(1.0)
8.3.19.0
8.3.11.1
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
fefd disable — disable far-end failure detection on an interface.
fefd reset — enable FEFD globally on the system.
fefd mode — change FEFD mode on an interface.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the S4820T.
Introduced on the Z9000.
Layer 2 947