Ip Igmp Last-Member-Query-Interval - Dell S6100 Configuration Manual

ip igmp last-member-query-interval

Change the last member query interval, which is the Max Response Time inserted into Group-Specific Queries sent in response to Leave
Group messages. This interval is also the interval between Group-Specific Query messages.
Syntax ip igmp last-member-query-interval milliseconds
To return to the default value, use the no ip igmp last-member-query-interval command.
Parameters
milliseconds
Defaults 1000 milliseconds
Command Modes INTERFACE
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.8.1.0
7.7.1.0
E-Series legacy
command
642 Internet Group Management Protocol (IGMP)
Enter the number of milliseconds as the interval. For IGMP version 2, the range is from
100 to 25599. For IGMP version 3, the range is from 100 to 65535. The default value is
1000 milliseconds.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
For IGMP version 2, the Interval range is from 100 to 25599. Introduced on the S6000-
ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.