Show Ip Igmp Snooping Mrouter - Dell S6100 Configuration Manual

Version
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
Usage Information This command displays the IGMP database, including configured entries for either all groups on all interfaces, all
groups on specific interfaces, or specific groups on specific interfaces.
The following describes the show ip igmp groups command shown in the following example.
Field
Group Address
Interface
Mode
Uptime
Expires
Last Reporter
Member Ports
Example
Dell# show ip igmp snooping groups
Total Number of Groups: 1
IGMP Connected Group Membership
Group Address
225.1.1.1
Member Ports: Te 1/1/1/1
Dell#

show ip igmp snooping mrouter

Display multicast router interfaces.
Syntax show ip igmp snooping mrouter [vlan number]
Parameters
vlan number
Command Modes
•
•
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Description
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S4810, S4820T, S5000, S6000, Z9000, and Z9500.
Description
Lists the multicast address for the IGMP group.
Lists the interface type, slot and port number.
Displays the IGMP version used.
Displays the amount of time the group has been operational.
Displays the amount of time until the entry expires.
Displays the IP address of the last host to be a member of the IGMP group.
Indicates the port channel. If the port channel is VLT, an asterisk (*) after the port
channel number indicates the port channel is locally down and that a remote VLT port is
up.
Interface
Vlan 10
Enter the keyword vlan then the vlan number. The range is from 1 to 4094.
EXEC
EXEC Privilege
Mode Uptime
IGMPv2-Compat 00:00:07
Internet Group Management Protocol (IGMP)
Expires Last Reporter
00:02:09 1.1.1.2
661