Permit - Dell S6100 Configuration Manual

Version
8.4.2.1
8.2.1.0
7.8.1.0
7.4.1.0
Usage Information The number of entries allowed per ACL is hardware-dependent. For detailed specification on entries allowed per
ACL, refer to your line card documentation. You can create an IPv6 ACL for control-plane traffic policing for
OSPFv3, in addition to the CoPP support for VRRP, BGP, and ICMP.

permit

To configure a filter that matches the filter criteria, select an IPv6 protocol number, ICMP, IPv6, TCP, or UDP.
Syntax permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp}
To remove this filter, you have two choices:
•
•
Parameters
ip-protocol-number
icmp
ipv6
tcp
udp
Defaults Not configured.
Command Modes ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.0.2.0
8.3.19.0
8.3.7.0
Description
Introduced on the S-Series.
Introduced on the E-Series.
Introduced on the C-Series. Increased the name string to accept up to 140 characters.
Prior to version 7.8.1.0, names are up to 16 characters long.
Introduced on the E-Series.
Use the no seq sequence-number command syntax if you know the filter's sequence number
Use the no permit {ipv6-protocol-number | icmp | ipv6 | tcp | udp} command
Enter an IPv6 protocol number. The range is from 0 to 255.
Enter the keyword icmp to filter internet Control Message Protocol version 6.
Enter the keyword ipv6 to filter any internet Protocol version 6.
Enter the keyword tcp to filter the Transmission Control protocol.
Enter the keyword udp to filter the User Datagram Protocol.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the S4810.
Access Control Lists (ACL) 231