Dell S6100 Configuration Manual page 326

log
threshold-in msgs
count
interval minutes
monitor
Defaults
By default, 10 ACL logs are generated if you do not specify the threshold explicitly.
The default frequency at which ACL logs are generated is 5 minutes. By default, flow-based monitoring is not
enabled.
Command Modes ACCESS-LIST
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.11(2.0P0)
9.10(0.1)
9.10(0.0)
9.10(0.0)
9.8(2.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.4(0.0)
9.5(0.1)
9.3.0.0
Usage Information
When the configured maximum threshold is exceeded, generation of logs is stopped. When the interval at which
ACL logs are configured to be recorded expires, the subsequent, fresh interval timer is started and the packet
count for that new interval commences from zero. If ACL logging was stopped previously because the configured
threshold is exceeded, it is re-enabled for this new interval.
326 Access Control Lists (ACL)
The ICMP packets cannot be filtered using mirroring ACL.
(OPTIONAL) Enter the keyword log to enable the triggering of ACL log messages.
(OPTIONAL) Enter the threshold-in-msgs keyword followed by a value to indicate
the maximum number of ACL logs that can be generated, exceeding which the generation
of ACL logs is terminated. with the seq, permit, or deny commands. You can enter a
threshold in the range of 1-100.
(OPTIONAL) Enter the keyword interval followed by the time period in minutes at
which ACL logs must be generated. You can enter an interval in the range of 1-10 minutes.
(OPTIONAL) Enter the keyword monitor when the rule is describing the traffic that you
want to monitor and the ACL in which you are creating the rule is applied to the
monitored interface.
Description
Added the type parameter to filter the ICMP packets based on the type and code on the
S6000, S6000–ON, S6100–ON, Z9100–ON.
Introduced on the S6010-ON and S4048T-ON.
Introduced on the S3148.
Introduced on the S6100.
Introduced on the S3100 series.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000–ON.
Added support for flow-based monitoring on the S4810, S4820T, S6000, and Z9000
platforms.
Introduced on the Z9500.
Added support for logging of ACLs on the S4810, S4820T, and Z9000 platforms.