Dell S6100 Configuration Manual page 55

1 Verify that you are logged in to CONFIGURATION mode.
2 Use the router bgp command, and then enter the AS number. The prompt changes to include conf-router_bgp.
You can return to CONFIGURATION mode by using the exit command.
ROUTER ISIS Mode
To enable and configure Intermediate System to Intermediate System (ISIS), use ROUTER ISIS mode. For more information, see
Intermediate System to Intermediate System
To enter ROUTER ISIS mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Use the router isis command. The prompt changes to include conf-router_isis.
You can return to CONFIGURATION mode by using the exit command.
ROUTER OSPF Mode
To configure OSPF, use ROUTER OSPF mode. For more information, see
To enter ROUTER OSPF mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the router ospf {process-id} command. The prompt changes to include conf-router_ospf-id.
You can switch to INTERFACE mode by using the interface command or you can switch to ROUTER RIP mode by using the router
rip command.
ROUTER OSPFV3 Mode
To configure OSPF for IPv6, use ROUTER OSPFV3 mode.
To enter ROUTER OSPFV3 mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the ipv6 router ospf {process-id} command. The prompt changes to include conf-ipv6-router_ospf.
You can return to CONFIGURATION mode by using the exit command.
ROUTER RIP Mode
To enable and configure Router Information Protocol (RIP), use ROUTER RIP mode. For more information, see
Protocol (RIP).
To enter ROUTER RIP mode:
1 Verify that you are logged in to CONFIGURATION mode.
2 Enter the router rip command. The prompt changes to include conf-router_rip.
You can return to CONFIGURATION mode by using the exit command.
(IS-IS).
Open Shortest Path First (OSPFv2).
Routing Information
CLI Basics 55