Ip Igmp Snooping Querier - Dell S6100 Configuration Manual

Version
7.6.1.0
7.5.1.0
E-Series legacy
command.
Usage Information The Dell Networking OS provides the capability of statically configuring the interface to which a multicast router is
attached. To configure a static connection to the multicast router, enter the ip igmp snooping mrouter
interface command in the VLAN context. The interface to the router must be a part of the VLAN where you
are entering the command.

ip igmp snooping querier

Enable IGMP querier processing for the VLAN interface.
Syntax ip igmp snooping querier
To disable IGMP querier processing for the VLAN interface, use the no ip igmp snooping querier
command.
Defaults Not configured.
Command Modes INTERFACE VLAN — (conf-if-vl-n)
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.5(0.1)
9.2(0.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
7.6.1.0
7.5.1.0
Description
Introduced on the S-Series.
Introduced on the C-Series.
Description
Introduced on the S6100–ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Introduced on the Z9500.
Introduced on the M I/O Aggregator. This command is supported in Programmable-Mux
(PMUX) mode only.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the S-Series.
Introduced on the C-Series.
Internet Group Management Protocol (IGMP) 659