Ip Dhcp Relay Information-Option - Dell S6100 Configuration Manual

Version
9.10(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.6(0.0)
9.2(1.0)
9.0.2.0
8.3.19.0
8.3.11.1
8.3.7.0
8.3.1.0
8.2.1.0
7.8.1.0
Usage Information
Allocate at least one FP block to ipmacacl before you can enable IP+MAC Source Address Validation and SAV
with VLAN option.
1
2
3

ip dhcp relay information-option

Enable Option 82.
Syntax ip dhcp relay information-option [remote-id {hostname | mac | WORD}] [circuit-d
{hostname:port}] [trust-downstream] [vpn]
Parameters
remote-id
remote-id
hostname
remote-id mac
remote-id WORD
circuit-id
570 Dynamic Host Configuration Protocol (DHCP)
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the S6000-ON.
Added the vlan keyword and the vlan-id variable . Introduced support for SAV on
port channels interfaces.
Introduced on the Z9500.
Introduced on the S6000.
Introduced on the S4820T.
Introduced on the Z9000.
Introduced on the S4810.
Introduced on the E-Series.
Added the keyword ipmac.
Introduced on the C-Series and S-Series.
Use the cam-acl l2acl command from CONFIGURATION mode.
Save the running-config to the startup-config.
Reload the system.
Enter the keyword remote-id to configure the system to enable the remote-id string in
option-82.
Enter the keywords remote-id hostname to configure the port as the remote id in
option–82.
Enter the keywords remote-id mac to configure the chassis MAC address as the
remote-id in option–82.
Enter the remote-id WORD option to configure the system to enable the remote-id
string in option 82.
Enter the keyword circuit-id to configure the system to enable the circuit-id string in
option–82.