Show Interface Pfc - Dell S6100 Configuration Manual

show interface pfc

Displays the PFC configuration applied to ingress traffic on an interface, including priorities and link delay.
Syntax show interface port-type slot/port[/subport] pfc {summary | statistics | detail
| buffer-threshold}
Parameters
port-type slot/
port[/subport] pfc
{summary |
statistics | detail |
buffer-threshold}
•
•
Command Modes
EXEC Privilege
CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.9(0.0)
9.8(1.0)
9.8(0.0P5)
9.8(0.0P2)
9.7(0.0)
9.2.(0.0)
8.3.19.0
8.3.12.0
8.3.16.0
Usage Information
To clear the PFC TLV counters, use the clear pfc counters interface command.
The following describes the show interface pfc summary command shown in the following example.
482 Data Center Bridging (DCB)
Enter the port-type slot and port PFC information. Enter the subport number if a 40G
port is fanned-out into 10G ports.
Enter the keyword summary for a summary list of results or enter the keyword detail
for a full list of results. Enter the keyword statistics to view pfc statistics. Use the
keyword buffer-threshold to display the buffer threshold details.
NOTE: This command also enables you to view information corresponding to a range of ports. However,
for Open Networking (ON) platforms the notation for specifying port range in the command is different
from how you specify in non-ON platforms.
For non-ON platforms, you can specify multiple ports as slot/port-range. For example, if you want to
display information corresponding to all ports between 1 and 4, specify the port range as show interfaces
interface-type 1/1 - 4.
For ON platforms, you can specify multiple ports as slot/port/[subport] - slot/port/
[subport]. For example, if you want to display information corresponding to all ports between 1 and 4,
specify the port range as show interfaces interface-type 1/1/1 - 1/1/4.
Description
Introduced on the S6100-ON.
Added support to display the interface configurations corresponding to a range of ports.
Introduced on the Z9100–ON.
Introduced on the S4048-ON.
Introduced on the S3048-ON.
Introduced on the Z9500.
Down status messages added.
Introduced on the S4820T.
Introduced on the S4810.
Introduced on the MXL 10/40GbE Switch IO Module.