Access-Class - Dell S6100 Configuration Manual

After entering the configuration mode of the ACL range, enter the following: type [inverse value] lower
threshold upper-threshold
Parameters
profile-name
type
inverse
lower threshold
upper-threshold
Defaults None
Command Modes CONFIGURATION
Command History
This guide is platform-specific. For command information about other platforms, refer to the relevant Dell
Networking OS Command Line Reference Guide.
The following is a list of the Dell Networking OS version history for this command.
Version
9.11(0.0)
Usage Information
Ensure that the ACL range feature is enabled before creating the profile names for the ranges using the feature
aclrange command. Reboot the system for the range profiles to come up.
Example
Dell(conf)#aclrange profile-name
Dell(conf-aclrange-profile-name)#
Dell(conf)#aclrange sportrange1
Dell(conf-aclrange-sportrange1)# l4srcport 1024 65535
Dell(conf)#aclrange destportrange1
Dell(conf-acl-destportrange1)# l4dstport 500 500
Dell(conf)#aclrange inverserange
Dell(conf-acl-inverserange)# l4dstport inverse 1000
Related Commands feature

access-class

Apply a standard ACL to a terminal line.
Syntax access-class access-list-name [ipv4 | ipv6]
To remove an ACL, use the no access-class command.
Parameters
access-list-name
ipv4
ipv6
Enter a valid name for the range profile.
Specify the type of the L4 port as source or destination.
Enter the keyword inverse followed by a value. This is used as a negative (not equal to)
match.
Enter the minimum inclusive value of the range.
Enter the maximum inclusive value of the range.
Description
Introduced on the S6000-ON, S6100-ON, Z9100-ON.
aclrange— Enable the ACL range.
Enter the name of a configured Standard ACL, up to 140 characters.
Enter the keyword ipv4 to configure an IPv4 access class.
Enter the keyword ipv6 to configure an IPv6 access class.
Access Control Lists (ACL) 183