Clear Ip Dhcp - Dell S6100 Configuration Manual

Dynamic Host Configuration Protocol (DHCP)
Dynamic host configuration protocol (DHCP) is an application layer protocol that dynamically assigns IP addresses and other configuration
parameters to network end-stations (hosts) based on the configuration policies the network administrators determine.
Topics:
• Commands to Configure the System to be a DHCP Server
• Commands to Configure Secure DHCP
• Commands to Configure DNS
Commands to Configure the System to be a DHCP
Server
To configure the system to be a DHCP server, use the following commands.

clear ip dhcp

Reset the DHCP counters.
Syntax clear ip dhcp [binding {address} | conflict | server statistics]
Parameters
binding
address
conflicts
server statistics
Defaults None
Command Modes EXEC Privilege
Command History
This guide is platform-specific. For command information about other platforms, see the relevant Dell Networking
OS Command Line Reference Guide.
Version
9.10(0.0)
9.8(1.0)
542 Dynamic Host Configuration Protocol (DHCP)
Enter the keyword binding to delete all entries in the binding table.
Enter the IP address to clear the binding entry for a single IP address.
Enter the keyword conflicts to delete all of the log entries created for IP address
conflicts.
Enter the keywords server statistics to clear all the server counter information.
Description
Introduced on the S6100-ON.
Introduced on the Z9100–ON.
13