Deny Udp - Dell S6100 Configuration Manual

Hide thumbs Also See for S6100:
Table of Contents

Advertisement

Example
An ACL rule with a TCP port range of 4000–8000 uses eight entries in the CAM.
Rule#
1 0000111110100000 1111111111100000 4000 4031 32
2 0000111111000000 1111111111000000 4032 4095 64
3 0001000000000000 1111100000000000 4096 6143 2048
4 0001100000000000 1111110000000000 6144 7167 1024
5 0001110000000000 1111111000000000 7168 7679 512
6 0001111000000000 1111111100000000 7680 7935 256
7 0001111100000000 1111111111000000 7936 7999 64
8 0001111101000000 1111111111111111 8000 8000 1
Total Ports: 4001
Example
An ACL rule with a TCP port lt 1023 uses only one entry in the CAM.
Rule# Data
1 0000000000000000 1111110000000000 0
Total Ports: 1024
Related Commands

deny udp

To drop user datagram protocol (UDP) packets meeting the filter criteria, configure a filter.
Syntax
deny udp {source mask | any | host ip-address} [operator port [port]]
{destination mask | any | host ip-address} [dscp] [operator port [port]] [count
[byte] [order] [fragments] [monitor [session-ID]] [no-drop]
To remove this filter, you have two choices:
Parameters
source
mask
any
host ip-address
dscp
operator
206
Access Control Lists (ACL)
Data
deny
— assign a filter to deny IP traffic.
deny udp
— assign a filter to deny UDP traffic.
Use the no seq sequence-number command if you know the filter's sequence number.
Use the no deny udp {source mask | any | host ip-address} {destination mask |
any | host ip-address} command.
Enter the IP address of the network or host from which the packets were sent.
Enter a network mask in /prefix format (/x) or A.B.C.D. The mask, when specified in
A.B.C.D format, may be either contiguous or non-contiguous.
Enter the keyword any to specify that all routes are subject to the filter.
Enter the keyword host then the IP address to specify a host IP address.
Enter this keyword dscp to deny a packet based on the DSCP value. The range is from 0
to 63.
(OPTIONAL) Enter one of the following logical operand:
eq = equal to
neq = not equal to
gt = greater than
Mask
From To #Covered
Mask
From To
1023 1024
#Covered

Advertisement

Table of Contents
loading

Table of Contents